You can either try them "as is" over the 30M (you'll likely get some degradation & noise, but beggars can't be choosers), or if you can find a piece of outboard gear that has balanced outputs, you could come out of the mixer into the outboard, set the gear for minimum or no effect if possible, and then drive your lines with that. After helping Clementine in Midtown, you'll have a nice subway ride before reaching a bright, unassuming area where. No matter what, any outputs you use besides the main outs are unbalanced (at least, according to the manual I'm looking at). The control room is the final area in Stray that you and B12 will enter together. You're not completely off the hook (in terms of interaction), since the preamp gain will affect both, as well as EQ. The reason for doing it this way is that whatever fader moves you make to modify the house mix will modify the monitor mix, UNLESS the monitor mix is completely independent of the fader postion (and using an aux send, set for pre-fader assures that). Typically if you're going to generate an on-stage monitor mix from the front-of-house mixer, you'd do that with a 'pre-fader' aux send, which this mixer has the ability to do. Part of my logic stems from the signal flow diagram, where it appears the sources for Control Room L&R are either the various solo buses, or from one of the group output pairs. It looks to me like the Control Room L & R out are intended for use in a recording situation, or in a monitor-mix situation (one of the connection diagrams that shows them connected to a floor wedge only makes sense to me if it's for the mixing engineer to spot check sounds via solo, etc). INTER always fully integrates the ergonomic user aspects in every workplace design.I've looked at a copy of the manual on the web, which has a signal flow diagram. A proper ergonomic workplace contributes not only to the well-being of the user, it also reduces absenteeism. Centralising the integration of all communication and control components offers users everything they need at their fingertips, enabling them to maintain full control over their process.Īnother important aspect within control room settings, both for employers and employees, are ergonomic requirements. This correct and quick communication handling contributes to an efficient operational process. Video walls are used to present information comprehensibly and simultaneously to everyone in the control room. The same is achieved for individual workplaces, as their state is a determining influence for productivity. By presenting this information in a dynamic and comprehensible lay-out, users maintain a clear process overview. Typical control rooms often show much and wide-ranging available information.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |